• 👍Maximum Derek👍@discuss.tchncs.de
    link
    fedilink
    English
    arrow-up
    7
    ·
    1 year ago

    If you’re asking about smoothing you need to build a fume chamber. You want the print bathed in a low steady steam bath of acetone (for ABS) or IPA (for PVB). A sufficient fume chamber isn’t difficult to build, you can find instruction all over. But, again, vaporized acetone is hazardous.

    • AFK BRB Chocolate@lemmy.world
      link
      fedilink
      arrow-up
      3
      ·
      1 year ago

      Depending on the amount of detail you need to keep, you really can just paint a little acetone straight into the print. You wouldn’t want to do that on, say, the face of a figurine, but for flat uniform surfaces is great, and much faster.