If I were to create a new instance of lemmy do I set up my own server in my house, or am I just creating an instance on one of the lemmy servers?
If I were to create a new instance of lemmy do I set up my own server in my house, or am I just creating an instance on one of the lemmy servers?
IIRC it’s technically possible to attach an external harddrive to a Raspberry Pi if it has its own power supply.
I seem to remember doing a botch where I took a USB hard disk drive that was supposed to get its power from the PC through the cable and rerouted the power over USB lines to a dedicated power brick.
My memory says I carefully removed a section of mantle in the middle of the drive’s USB cable, cut the power carrying lines but leaving the data lines intact, cut one end of a different USB cable, connected the power lines of that with the cut power lines of the drive’s cable (only on the drive side, obviously), put the intact end of the second cable into a USB charge plug, and connected the drive and RPi as if the RPi were a regular PC.
I’m pretty sure it worked.
I run my Pi directly from a USB SSD, no micro SD card installed.
SSDs ofc requires less power so it runs just fine!
Do the Pi’s USB ports not supply power??
Not enough for the needs of an HDD
Wouldn’t you just use a SSD? Are people actually connecting spinning discs to an Rpi?
I did at the time, if I remember correctly. It’s been years though, could have just been an old SSD model that used too much power for the Rpi.