• 👍Maximum Derek👍@discuss.tchncs.de
      link
      fedilink
      English
      arrow-up
      7
      ·
      1 year ago

      If you’re asking about smoothing you need to build a fume chamber. You want the print bathed in a low steady steam bath of acetone (for ABS) or IPA (for PVB). A sufficient fume chamber isn’t difficult to build, you can find instruction all over. But, again, vaporized acetone is hazardous.

      • AFK BRB Chocolate@lemmy.world
        link
        fedilink
        arrow-up
        3
        ·
        1 year ago

        Depending on the amount of detail you need to keep, you really can just paint a little acetone straight into the print. You wouldn’t want to do that on, say, the face of a figurine, but for flat uniform surfaces is great, and much faster.